RoboMowRC

This is a very early version not ready for use!

Project to monitor and control a RoboMow lawn mower via Bluetooth via an ESP32. Currently targeted to TTGO T-Beam board, which includes GPS and LoRaWan functionality.

Requirements

Currently a board with PSRAM and 4GB of Flash is required. To use OTA you need 8GB of flash.

ToDo

• [ ] Lots of things...

• [ ] Websocket: refresh webpage disconnects new and old session

• [ ] Webpage: Recoonect to websocket automatically?

• [ ] Homepage with RoboMow status view and controls

• [ ] RS and RC series status

• [ ] Lora: add frequency plan to UI

• [ ] Lora: add framecounter reset to UI

• [ ] BLE: check if BLE crashes when wrong motherboard serial is entered

• [ ] BLE: check why not proper connection if Serial is freshly entered

• [ ] Webpage: only auto start portal when no credentials configured

• [ ] Webpage: enable start portal on button press

• [ ] GPS: Store data for faster acquisition

• [ ] GPS: upload time for faster acquisition

• [ ] General: shrink code size to allow ota

• [ ] General: fix partion table to allow OTA

• [ ] General: shrink memory usage to be able to run without PSRAM

• [ ] General: Reduce Heap usage

• [ ] General: power saving

Done

• [x] Lora: send old GPS coordinate over different Fport (to avoid polluting TTN mapper)
• [x] Lora: send SF12 message every 6 hours and immediatly after theft?,
• [x] Lora: send regular SF7 message max every 5 minutes, normally every 15 minutes
• [x] Lora: add keys to UI
• [x] Lora: store frame counter in nvm
• [x] General: remove spiffs replace with NVM